The XtremIO Storage System is an all-flash array based on a scale out-architecture. The system uses building blocks called X-Bricks which can be clustered together.
An XtremIO storage system can include a single X-Brick or a cluster of multiple X-Bricks. The storage system is controlled via a dedicated Linux server called XtremIO Management Server (XMS). The XMS can be either a physical or a virtual server.
As part of routine discovery, the EMC XtremIO pattern is triggered on a storage device running a type of OS matching XtremIO Management Server SMI-S Provider. Once discovered, the storage entities are modeled in BMC Discovery.
Prerequisites
- XtremIO Array version 4.0.15-15 or higher
- XtremIO Management Server (XMS) version 4.2.1-6 or higher
- XMS Embedded SMI-S Provider running on port 5989
- Configure the XMS Embedded SMI-S Provider
- ECOM credentials. These credentials should be entered as WBEM credentials for the XtremIO Management Server SMI-S Provider IP address.
- WBEM credentials for the XMS Embedded SMI-S Provider:
- In the Add Credential page (Refer to the Adding Credentials page for detailed information):
Enter the XtremIO Management Server IP address
Enter the Username and Password to connect to the XMS Embedded SMI-S Provider as previously configured in the ECOM Administration and the XtremIO Storage Management Application
Select the HTTPS access protocol
Select the WBEM HTTPS port 5989
- Test the credentials (Refer to the Testing credentials page for detailed information):
Open Manage > Device Credentials
Select the previously configured XtremIO Device
From the Actions, drop-down list, select Test
- Scan the XtremIO Cluster (Refer to the Scanning IP addresses page for detailed information):
- In the Add Credential page (Refer to the Adding Credentials page for detailed information):
Supported Platforms
- EMC XtremIO Storage Array 4.0.15-15 or higher
Discovered Storage Information
Vendor Specific Information
No known vendor specific information.
Limitations
No known limitations.
